lll  Wear approved eye protection.

lll  Clean and lubricate beads and rim.

lll  Centralize rim band and tube to prevent pinching if tube-type rim.

lll  Note directional arrows on sidewall where applicable.

lll  Looks assembly on mounting machine or place in safety cage.

lll  Set air hose relief valve at 40 PSI.

lll  Use extention gauge and hose with clip-on air chuck. -stand back with no part of your body within the perimeter of the assembled tire and rim.

lll  Inflate with core in valve stem.

lll  Never inflate above 40 PSI to seat beads.

lll  Spin wheel to check bead seating, alignment and clearance.

"If the beads do not seat by 40 PSI, deflate and repeat above procedures."

Serious injury may result from tire failure due to underinflation/overloading.

Do not exceed accessory restrictions in motorcycle owners manual and max. Load on tire sidewalls.

Adjust inflation to minimum 36 PSI cold and to 40 PSI cold for dual riding or when fully loaded.